12/4/2023 0 Comments Deer feeder standCut a 1” wide hole in the bottom of the bucket.One ¼”-20 all-thread rods (threaded along the whole length) about 36” long.The feed is kept in the bucket until the can is moved by a washer slightly larger than the hole suspended on the rod an inch or so below the hole, just enough to keep the feed in the bucket until the rod is moved when a small amount of feed will drop to the ground. A large tin can is suspended from the bottom of the rod so the wind or nudging deer can cause the feed to fall from the hole. It uses a 5-gallon bucket to hold the feed, with a small hole cut into the bottom.Ī wooden bridge is fitted across the inside of the bucket about two inches from the bottom that suspends a length of an all-thread rod through the hole. You can also find pre-made drain caps at the store but make sure the holes are small enough to keep your feed in.Īnother easy-to-build and ridiculously affordable feeder. You can mount your new feeder to a tree with bungee cords, ratchet straps, or rope. The second eye-bolt will attach the lid to the pipe to keep the raccoons from raiding your feeder. Attach one eye-bolt in the top to use as a handle. Take the end cap that will cover the top of the feeder and drill one hole in the center and one in the side, with a corresponding hole in the main pipe.These will be used as strapping points to secure it to the tree. Drill holes along the side of the pipe to attach eye-bolts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |